Octopus Electronic Bricks, you can use them to build electronics projects just as easy as piling bricks. By using Octopus electronic bricks, you may connect Arduino/Freaduino compatible boards easily with various digital, analog, and I2C/Uart interfaces. These breadboard-less firm connections are prepared to extensive modules like potentiometers, sensors, relays, servos even buttons, just plug and play.
Octopus 5mmLED light Brick, and special sensors Arduino board and ambient light sensor extension combination, can be used in the interaction with the light works.
When the LED light module is connected to Arduino, the digital pin (LOW on, HIGH off) is used to control it. The brightness of LED can be controlled via PWM output.
The Freaduino Sensor Shield is the perfect shield to connect this sensor to Arduino. Or Freaduino UNO which we had a pre-stray Octopus Brick interface.
There are five colors for you to choose from. White(default), Red, Blue, Green, and Yellow.
Pin Definition :1 Signal(Yellow) 2 Vcc(Red) 3 GND(black)
|5mm LED Brick||1|
|Analog Sensor Cable||1|
Connect LED brick to P0 port on OCTOPUS:BIT.
You can see the whole program from the link
Or you can download it from the page below.
LED brick flashes at a 1-second interval.